CISCO MAC ADDRESS IDENTIFIER SOFTWARE
CISCO MAC ADDRESS IDENTIFIER CODE
CISCO MAC ADDRESS IDENTIFIER MAC

For example, ARP requests do not use IPv4, but the ARP message is sent as an Ethernet broadcast. However, not all Ethernet broadcasts carry IPv4 broadcast packets.

CISCO MAC ADDRESS IDENTIFIER MAC

When the IPv4 broadcast packet is encapsulated in the Ethernet frame, the destination MAC address is the broadcast MAC address FF-FF-FF-FF-FF-FF in hexadecimal (or 48 1s in binary).ДHCP for IPv4 is an example of a protocol that uses Ethernet and IPv4 broadcast addresses. The IPv4 destination address is a broadcast address, 192.168.1.255. The source host sends an IPv4 broadcast packet to all devices on its network. This means that the address is permanently encoded into the ROM chip. Sometimes a MAC address is referred to as a burned-in address (BIA) because the address is hard coded into read-only memory (ROM) on the NIC. In such a case, it is necessary to modify the MAC address with a new NIC or make modifications by using software.

CISCO MAC ADDRESS IDENTIFIER SOFTWARE

However, it is possible for duplicate MAC addresses to exist because of mistakes made during manufacturing, mistakes made in some virtual machine implementation methods, or modifications made using one of several software tools. It is the responsibility of a vendor to ensure that no two of its devices are assigned the same MAC address. Therefore, the Ethernet MAC address of that device would be 00-60-2F-3A-07-BC.

CISCO MAC ADDRESS IDENTIFIER CODE

Cisco would configure the device with a unique vendor code such as 3A-07-BC.

Because 1 byte equals 8 bits, we can also say that a MAC address is 6 bytes in length.ДЇigure 7-8 The Ethernet MAC Address StructureДЇor example, say that Cisco needs to assign a unique MAC address to a new device, and the IEEE has assigned Cisco the OUI 00-60-2F. MAC addressing provides a method for device identification at the data link layer of the OSI model.ДЄn Ethernet MAC address is a 48-bit address expressed using 12 hexadecimal digits, as shown in Figure 7-7. The MAC address is used to identify the physical source and destination devices (NICs) on the local network segment. In an Ethernet LAN, every network device is connected to the same shared medium. If such conversions are required, convert the decimal or hexadecimal value to binary and then to convert the binary value to either decimal or hexadecimal as appropriate.

You might have to convert between decimal and hexadecimal values. Hexadecimal may also be represented using a subscript 16 or by using the hex number followed by an H (for example, 73H). Hexadecimal numbers are often represented by a value preceded by 0x (for example, 0x73) to distinguish between decimal and hexadecimal values in documentation. For example, in Figure 7-6, the binary value 0000 1010 is shown to be 0A in hexadecimal. When using hexadecimal, leading zeros are always displayed to complete the 8-bit representation. Figure 7-6 Selected Examples of Decimal to Binary to Hexadecimal Conversions

Cisco mac address identifier